级间衬套
，，，距离衬套
，，，候部衬套直接的关系
，，，和泵轴轴颈阻止阀接触点及接触角度:标准划定下瓦背与轴承座接触面积应在60%以上
，，，轴颈处滑动接触面上的接触点密度坚持在每平方厘米2一4个点
，，，接触角度坚持在60“一90”。。。
。。 

支架和底板。。。
。。实时发明有振动的支持件的疲劳情形
，，，防止由于强度和刚度降低造成固有频率下降。。。
。。 

间隙和易损件。。。
。。级间衬套
，，，距离衬套
，，，细密加工">大连G22恒峰机械细密加工候部衬套包管电机轴承间隙合适;适当减压阀调解叶轮与涡壳之间的间隙;按期检查、替换叶轮口环、泵体口环、级间衬套、隔板衬套等易磨损零件。。。
。。 

The direct relationship between the inter stage liner, spacing liner, and waiting part liner, as well as the contact point and contact angle with the pump shaft neck globe valve: According to standard regulations, the contact area between the bearing back and the bearing seat should be within 60%

Above, the contact point density on the sliding contact surface at the journal is maintained at 2-4 points per square centimeter, and the contact angle is kept between 60 "and 90". Bracket and base plate. Timely detect the fatigue situation of vibrating support components to prevent a decrease in natural frequency due to a decrease in strength and stiffness.

Gap and vulnerable parts. Inter level bushings, spacing bushings, and precision machined bushings from Dalian Lianghui Machinery ensure appropriate clearance between motor bearings; Adjust the gap between the impeller and the volute appropriately with a pressure reducing valve; Regularly inspect and replace wear-resistant parts such as impeller mouth rings, pump body mouth rings, inter stage bushings, and baffle bushings.